Small Ondulator Corrugating Rolling Mill With 4 Sizes Busch Burs Designed as a direct-fit replacement

Designed as a direct-fit replacement component for supported Badeco hammer handpiece models

Supplied 1/2 hard

GlenSteel is engineered for predictable wear to help reduce the risk of sudden tool failure

Wide size range accommodates a variety of bangle bracelet styles

while the dial dimming knob lets you dial in exactly the brightness level your work requires

Small Ondulator Corrugating Rolling Mill With 4 Sizes Busch Burs Designed as a direct-fit replacementThis smaller corrugating rolling mill also known as an ondulator is a simple, direct drive mill designed for adding a corrugated effect to thin gauges of soft metal sheet. It is used primarily for corrugating thin bezel wire and decorative sheet work. The mill must be mounted in a vise or attached securely to a workbench before use. For use with soft precious metal sheet up to 24mm wide. Best results are achieved with 30 gauge (0. 25mm 0. 010") sheet.